Program 11 : System Numbering; System Numbering - NEC Univerge SV8100 Programming Manual

Level:
IN
Description
Use
Program 11-01 : System Numbering
numbering plan assigns the first and second digits dialed and affects the digits
an extension user must dial to access other extensions and features, such as
service codes and trunk codes. If the default numbering plan does not meet
the site requirements, use this program to tailor the system numbering to the
site.
Changing the numbering plan consists of three steps:
Step 1: Enter the digit(s) you want to change
You can make either single or two digit entries. In the Dialed Number column
in the
nX rows (e.g., 1X) are for single digit codes. The remaining rows (e.g., 11, 12,
etc.) are for two digit codes.
Programming Manual

Program 11 : System Numbering

Improperly programming this option can adversely affect system
operation. Make sure you thoroughly understand the default numbering
plan before proceeding. If you must change the standard numbering, use
the chart for Table 2-3 System Numbering Default Settings on
page 2-75
to keep careful and accurate records of your changes.
Before changing your numbering plan, use PC Pro to make a backup
copy of your system data.
Table 2-3 System Numbering Default Settings on page 2-75
Entering a single digit affects all the Dialed Number entries beginning with
that digit. For example, entering 6 affects all number plan entries beginning
with 6. The entries you make in step 2 and step 3 below affect the entire
range of numbers beginning with 6. (For example, if you enter 3 in step 2
the entries affected are 600~699. If you enter 4 in step 2 below, the entries
affected are 6000~6999.)

11-01 : System Numbering

to set the system numbering plan. The
CAUTION!
Program
11
table, the
2 - 73