NEC Univerge SV8100 Programming Manual page 310

Issue 1.0
Input Data
Item
Item
No.
06 Permit Code
Table
07 Deny Restriction
Table
08
PBX Access
Code
09 Specific Dial
Outgoing Code
10 Outgoing Call
Code Setup
2 - 270
Table Input Data
~ Dial
1 4
(Up to 12
(table)
digits)
~
001 200
(Entry)
~ Dial
1 4
(Up to 12
(table)
digits)
~
1 60
(Entry)
~
Dial
1 4
(Up to two
digits)
~ Dial
1 20
(Up to eight
digits)
~
Dial
1 20
(Up to four
digits)
Default
~ This option lets you program the
Table 1 4 = No Setting
Permit Code Tables. If the system
has Toll Restriction enabled, users
can dial numbers only if permitted
by these tables and the Common
Permit Table (21-06-04). There are
four Permit Code Tables, with up to
200 entries in each table. The
system permits calls exactly as you
enter the code.
~ This option lets you program the
Table 1 4 = No Setting
Restrict Code Tables. If the system
has Toll Restriction enabled, users
cannot dial numbers listed in these
tables. There are four Restrict
Code Tables, with up to 200 entries
in each table. The system restricts
calls exactly as you enter the code.
~
Use this option to enter the PBX
Table 1 4 = No Setting
Access Code. When the system is
behind a PBX, this is the code
users dial to access a PBX trunk.
Toll Restriction begins after the
PBX access code. For PBX trunks
(Program 14-04) the system only
Toll Restricts calls that contain the
access code. Always program this
option when the system is behind a
PBX, even if you don't want to use
Toll Restriction. PBX Access
Codes can have up to two digits,
using 0-9, #,
(don't care). When using Account
Codes, do not use an asterisk in a
PBX access code. Otherwise, after
the , the trunk stops sending
digits to the central office. Entries
1~4 correspond to the 4 PBX
Access Codes. Each code can
have up to two digits.
No Setting
No Setting
Program 21 : Outgoing Call Setup
UNIVERGE SV8100
Description
and LINE KEY 1