NEC Univerge SV8100 Programming Manual page 417

UNIVERGE SV8100
When entering names in the procedures below, refer to this chart. Names can have up to
Input Data
Item
No.
Programming Manual
Use this keypad
digit . . .
#
Conf
Hold
Internal Paging Group Number
01 Internal Paging Group Name
Assign name to Internal Paging Groups (i.e., Page
Zones). The system shows the name you program on the
telephone display.
Default
Item 01 : Internal Paging Group Name
Extension
Paging Group
01
02
:
64
Key for Entering Names
12 digits.
When you want to. . .
# = Accepts an entry (only required if two letters on the same key
are needed - ex: TOM). Pressing
programming mode, use the right arrow soft key instead to accept
and/or add a space.)
Clear the character entry one character at a time.
Clear all the entries from the point of the flashing cursor and to the
right.
Item
Name
Group 1
Group 2
:
Group 64
Issue 1.0
# again = Space. (In system
01~64
Input Data
Up to 12 Characters Refer to
Default
default
table.
2 - 377