NEC Univerge SV8100 Programming Manual page 49

UNIVERGE SV8100
Item
No
01
02
03
04
05
06
07
08
09
10
11
14
15
17
Programming Manual
For BRIA PKG Setup
ISDN Line Number
Item
ISDN Line Mode
Logical Port Number
The starting port number of a BRI
line is displayed. Two logic ports are
automatically assigned to a BRI line.
Connection Type
Layer 3 Timer Type
Each timer value of Layer 3 is set up
for every type using Program 81-06
(T-Bus).
CLIP Information Announcement
Based on this setting, the system
includes a Presentation Allowed (1) or
Presentation Restricted (0) in the Setup
message to allow or deny the Calling
Party Number. Program 15-01-04 must
also be set to 1 if this option is enabled.
--- Not Used ---
--- Not Used ---
Dial Sending Mode
ISDN Protocol definition
Dial Information Element
ISDN Protocol definition
[Only when Dialing Sending Mode
(10-03-08) is set for 1 (Overlap Sending]
Master/Slave System
If set to 0, system is synchronized to
network clock. If set to 1, system is not
synchronized to the network clock.
--- Not Used ---
--- Not Used ---
--- Not Used ---
ISDN Line Ringback Tone
If Telco does not provide ringback tone,
SV8100 can if set to 1:Enable.
01~04
Input Data
0 = Not Used
1 = T-Point
0 = Not Used
1 = For T-Bus (1~200)
0 = Point-to-Multipoint
1 = Point-to-Point
1~5
0 = Disable
1 = Enable
0 = Enblock Sending
1 = Overlap Sending
0 = Keypad Facility
1 = Called Party Number
0 = Slave System
1 = Master System
0 = Disable
1 = Enable
Issue 1.0
Default
1
0
0
1
1
1
0
0
0
2 - 9