Analog Trunk Data Setup - NEC Univerge SV8100 Programming Manual

Issue 1.0
Level:
IN
Description
Use Program 14-02 : Analog Trunk Data Setup to set the basic options for each
analog trunk port. Refer to the table below for a description of each option, its range
and default setting.
Input Data
Item
No.
01
02
03
04
05
2 - 138
Program 14 : Trunk, Basic Setup
Trunk Port Number
Item
Signaling Type (DP/DTMF)
This option sets the signaling type for
the trunk.
Ring Detect Type
This option sets Extended Ring Detect
or Immediate Ring Detect for the trunk.
For T1 loop/ground start trunks, this
option must be set to 1 for the trunks to
ring and light correctly.
Flash Type
This option selects the flash type (open
loop flash or ground). Always set this
option for open loop flash.
Hooking Type
This option lets you use Flash for
Timed Flash (Program 81-01-14) or
Disconnect (Program 81-01-15). (A
user implements Flash by pressing the
FLASH key while on a trunk call.)
Dial Tone Detection for Manually
Accessed Trunks
Use this option enable/disable dial tone
detection for directly accessed trunks.
If disabled, the system outdials on the
trunks without monitoring for dial tone.

14-02 : Analog Trunk Data Setup

Input Data
0 = Dial Pulse (10
PPS)
1 = Dial Pulse (20
PPS)
2 = DTMF
0 = Normal/delayed
1 = Immediate
Ringing
0 = Open Loop Flash
1 = Ground
0 = Timed Flash
(Hooking)
1 = Disconnect (Cut)
0 = Dial Tone
Detection Not
Used
1 = Dial Tone
Detection Used
Program 14 : Trunk, Basic Setup
UNIVERGE SV8100
001~200
Related
Default
Program
2
1
0
0 81-10-07
81-10-08
0 21-01-04