Ricoh D072 Service Manual page 92

Printer/Scanner Unit
17. Attach the ferrite core [A] to the network cable and attach the cable to the copier if a
network cable is used.
The ferrite core must be attached next to the network cable connector [B].
18. Attach the "Power Source: OFF" decal [C] to the under of main power switch at the left
side of the machine as shown above.
19. Plug in the power cord, and turn on the main switch.
20. For the North America model only: Perform the interface settings.
1) Start the SP mode.
2) Select SP5-985-001 (NIC setting) and change the setting value to "1" (ON).
3) Select SP5-985-002 (USB setting) and change the setting value to "1" (ON).
4) Turn the main switch off and on.
21. Perform the Printer/Scanner settings.
1) Start the SP mode.
2) Select SP5-801-001 and execute the initialization.
3) Exit the SP mode, and then start the UP mode.
4) Select the "@Remote Service" ("User Tool" > "System Settings > Administrator
Tools" > "Extended Security" > @Remote Service") and select "Prohibit."
5) Exit the UP mode, and then start the SP mode.
6) Select SP5-870-003 and execute initialization for @Remote.
7) Select SP5-907-001 and specify the "Plug & Play."
8) Select SP5-870-001 and execute writing certification for `Remote.
9) Select SP5-302-002 and specify the time zone.
10) Select SP5-307-001, 003, and 004 and specify the daylight-saving-time settings.
D067/D068/D069/D072 2-46 SM