Ricoh D072 Service Manual page 367

System Service Mode (F/SPF: D068/D069)
Ans Timing Adj
When the Call Center calls out to a embedded RCG-M modem, it sends a
repeating ID tone (*#1#). This SP sets the time the line remains open to send
these ID tones after the number of the embedded RCG-M modem is dialed up
162
and connected.
[0 to 24/ 1 /1 /step]
The actual amount of time is this setting + 2 sec. For example, if you set "2"
the line will remain open for 4 sec.
Access Point
This is the number of the dial-up access point for embedded RCG-M. If no
setting is done for this SP code, then a preset value (determined by the
163
country selected) is used.
Default: 0
Allowed: Up to 16 alphanumeric characters
Comm Line
This SP sets the connection conditions for the customer. This setting
dedicates the line to embedded RCG-M only, or sets the line for sharing
between embedded RCG-M and a fax unit.
[0 or 1 / 0 / - ]
0: Line shared by embedded RCG-M/Fax
164
1: Line dedicated to embedded RCG-M only
Modem Serial Number
173
This SP displays the serial number registered for the embedded RCG-M.
D067/D068/D069/D072
If this setting is changed, the copier must be cycled off and on.
SP5816 187 determines whether the off-hook button can be used to
interrupt an embedded RCG-M transmission in progress to open the
line for fax transaction.
5-58 SM Appendix