Ricoh D072 Service Manual page 338

Clr For Cut Remove
5120*
Specifies the condition to reset the copy job settings when the key counter is
removed.
0: Y = Yes: The settings are cleared when the counter is removed.
1: StdBy = Standby only: The settings are cleared when the counter is
5120 1
removed at the end of a job.
2: N = No: The settings are not cleared under either condition.
As for duplex copying, the job settings are always preserved regardless of
these setting.
5121* Counter Up Timing
Selects the count-up timing.
5121 1 0 = Feed: At each paper feed
1= Exit: At each paper exit
Fax Prnt Cnt Off
Enables or disables the automatic print out without an accounting device. This
5167
SP is used when the receiving fax is accounted by an external accounting
device.
001 Fax Prnt Cnt Off
CE Login
5169
If you change the printer bit switches, you must 'log in' to service mode with
this SP before you go into the printer SP mode.
001 CE Login
SM Appendix
System Service Mode (F/SPF: D068/D069)
[0=Yes / 1=Standby only / 2=No]
[0 = Feed In / 1 = Exit]
[ 0 or 1 / 0 / – ]
CTL 0: Automatic printing
1: No automatic printing
[0 or 1 / 0 / - ]
CTL 0: Disabled
1: Enabled
5-29 D067/D068/D069/D072