Ricoh D072 Service Manual page 477

System Service Mode (Basic: D067/D072)
SP6-XXX (Peripherals)
ADF Adjustment (
Area")
6006*
NOTE: Available menus depend on the machine model and its configuration.
StoS/Front Regist
6006 1
Adjusts the side-to-side registration for the front side of the original, for ARDF
mode. Use the
Leading Regist
6006 2
Adjusts the leading edge registration for ARDF mode. Use the
select "+" or "–" before entering the value.
Trailing Erase
6006 3
Adjusts the trailing edge erase margin for ARDF mode. Use the
select "+" or "–" before entering the value.
S to S/ Rear Regist
6006 4
Adjusts the side-to-side registration for the 2nd side of the original, for ARDF
mode. Use the
Sub-scan Magnif
6006 5
Adjusts the sub-scan magnification for the ARDF.
Origin Curl Adj
6006 6
Turns on or off the skew correction at 2nd side scanning. This SP is activated
only when the duplex mode is selected.
Skew Correction
6006 7
Adjusts the original buckle for the skew correction at 2ns side scanning. This
SP is activated only when SP6-006-006 is set to "1 (Yes)".
D067/D068/D069/D072
"DF Image Adjustment" in the "Adjusting Copy Image
[–5.0 to +5.0 / 0.0 / 0.1 mm/step]
key to select "+" or "–" before entering the value
[–5.0 to +5.0 / 0.0 / 0.1 mm/step]
[–3.0 to +3.0 / –1.5 / 0.1 mm/step]
[–5.0 to +5.0 / 0.0 / 0.1 mm/step]
key to select "+" or "–" before entering the value
[–0.9 to +0.9 / 0.0 / 0.1 %/step]
[0 = No / 1 = Yes]
[–20 to +20 / 0.0 / 1 mm/step]
5-168
key to
key to
SM Appendix