Bit Switches; System Switches - Ricoh D072 Service Manual

7.2 BIT SWITCHES

This section is used only for F/SPF models (D068/D069).
Do not adjust a bit switch or use a setting that is described as "Not used", as this
may cause the machine to malfunction or to operate in a manner that is not
accepted by local regulations. Such bits are for use only in other areas, such as
Japan.
Default settings for bit switches are not listed in this manual. Refer to the System
Parameter List printed by the machine.

7.2.1 SYSTEM SWITCHES

System Switch 00 [SP No. 1-101-001]
No FUNCTION
Dedicated transmission
0 parameter programming
0: Disabled, 1: Enabled
1 Not used
Technical data printout on the
Journal
2
0: Disabled
1: Enabled
SM Appendix
COMMENTS
Set this bit to 1 before changing any dedicated
transmission parameters.
Reset this bit to 0 after programming dedicated
transmission parameters.
Do not change
1: Instead of the personal name, the following data
are listed on the Journal for each G3
communication.
7-9
Bit Switches
D067/D068/D069/D072