Ricoh D072 Service Manual page 552

System Switch 09 [SP No. 1-101-010]
No FUNCTION
0
Not used
Inclusion of communications
on the Journal when no image
1
data was exchanged.
0: Disabled 1: Enabled
Automatic error report printout
2
0: Disabled 1: Enabled
Printing of the error code on
3 the error report
0: No 1: Yes
4
Not used
Power failure report
5
0: Disabled 1: Enabled
Conditions for printing the
protocol dump list
6 0: Print for all communications
1: Print only when there is a
communication error
SM Appendix
COMMENTS
Do not change these settings.
0: Communications that reached phase C
(message tx/rx) of the T.30 protocol are listed on
the Journal.
1: Communications that reached phase A (call
setup) of T.30 protocol are listed on the Journal.
This will include telephone calls.
0: Error reports will not be printed.
1: Error reports will be printed automatically after
failed communications.
1: Error codes are printed on the error reports.
Do not change this setting.
1: A power failure report will be automatically
printed after the power is switched on if a fax
message disappeared from the memory when the
power was turned off last.
This switch becomes effective only when system
switch 00 bit 6 is set to 1.
1: Set this bit to 1 when you wish to print a protocol
dump list only for communications with errors.
7-13
Bit Switches
D067/D068/D069/D072