Paper Tray Unit Heater
Note that [1] is the ground screw you removed in the previous step and [4] and [5] are
the two supplied heater fastening screws.
Be sure to position the ground wire [3] and heater harness [6] so that they are
out of the way of the copier when you set it on the paper tray unit.
5.
Set the copier on the paper tray unit.
6.
Screw the paper tray unit into place using three supplied PTU fastening screws.
7.
Open the front door and remove the copy tray [7] (
8.
Close the front door.
D067/D068/D069/D072
×1).
2-20
SM