Ricoh D072 Service Manual page 569

Bit Switches
Subject corresponding to mail post database
0: Standard subject
1: Mail post database subject
The standard subject is replaced by the mail post database subject in the following
three cases:
1) When the service technician sets the service (software) switch.
1 2) When memory sending, delivery specified by F code or SMTP reception is done.
3) With relay broadcasting (1st stage without the Schmidt 4 function).
This switch does not apply for condition 3) when the RX system is set up
for memory sending, delivery by F-code, sending with SMTP RX and when
operators are using FOL (to prevent problems when receiving
transmissions).
2-7 Not Used
I-fax Switch 05 [SP No. 1-102-006]
No FUNCTION
0 Mail Addresses of SMTP Broadcast Recipients
Determines whether the e-mail addresses of the destinations that receive
transmissions broadcasted using SMTP protocol are recorded in the Journal.
For example:
"1st destination + Total number of destinations: 9" in the Journal indicates a
broadcast to 9 destinations.
0: Not recorded
1: Recorded
1 I-Fax Automatic Re-dial Setting
0: OFF
1: ON
2-7 Not used
D067/D068/D069/D072
COMMENTS
Determines whether the I-fax automatically
redials when an error occurs.
7-30 SM Appendix