Ricoh D072 Service Manual page 625

Dedicated Transmission Parameters
7.4 DEDICATED TRANSMISSION PARAMETERS
This section is used only for F/SPF models (D068/D069).
There are two sets of transmission parameters: Fax and E-mail
Each Quick Dial Key and Speed Dial Code has eight bytes of programmable parameters
allocated to it. If transmissions to a particular machine often experience problems, store
that terminal's fax number as a Quick Dial or Speed Dial, and adjust the parameters
allocated to that number.
The programming procedure will be explained first. Then, the eight bytes will be described.
7.4.1 PROGRAMMING PROCEDURE
1. Set the bit 0 of System Bit Switch 00 to 1.
2. Enter Address Book Management mode ([User Tools]> System Settings>
Administrator Tools > Address Book Management).
3. Select the address book that you want to program.
4. Press the "Dest." Key to enter the fax and e-mail parameter settings.
5. For the fax parameter, select "Fax Settings", for the E-mail parameter, select "E-mail
Settings".
6. Press the "OK" key, and then press "Start" key. Make sure that the LED of the Start
button lights green.
7. The settings for the switch 00 are now displayed. Press the bit number that you wish to
change.
8. To scroll through the parameter switches, either:
9. Select the next switch: press "Next" or Select the previous switch: "Prev." until the
correct switch is displayed. Then go back to step 6.
10. After the setting is changed, press "OK" key.
11. After finishing, reset bit 0 of System Bit Switch 00 to 0.
D067/D068/D069/D072 7-86 SM Appendix