Ricoh D072 Service Manual page 609

Hide thumbs Also See for D072:

Table of Contents

NCU Parameters

7.3 NCU PARAMETERS

This section is used only for F/SPF models (D068/D069).

The following tables give the RAM addresses and the parameter calculation units that

the machine uses for ringing signal detection and automatic dialing. The factory

settings for each country are also given. Most of these must be changed by RAM

read/write (SP2-102), but some can be changed using NCU Parameter programming

(SP2-103); if SP2-103 can be used, this will be indicated in the Remarks column. The

RAM is programmed in hex code unless (BCD) is included in the Unit column.

Country/Area code for NCU parameters

Use the Hex value to program the country/area code directly into this

address, or use the decimal value to program it using SP2-103-001

D067/D068/D069/D072

South Africa

Chapters

Table of Contents

D067 D069 D068