Ricoh D072 Service Manual page 507

Hide thumbs Also See for D072:

Table of Contents

Fax Error Codes

The line was disconnected

due to a timeout in V.34

phase 2 – line probing.

D067/D068/D069/D072

Suggested Cause/Action

The guard timer expired while starting these

phases. Serious noise, narrow bandwidth, or

low signal level can cause these errors.

If these errors happen at the transmitting terminal:

Try making a call at a later time.

Try using V.17 or a slower modem using

dedicated tx parameters.

Try increasing the tx level.

Try adjusting the tx cable equalizer setting.

If these errors happen at the receiving terminal:

Try adjusting the rx cable equalizer setting.

Try increasing the tx level.

Try using V.17 or a slower modem if the same

error is frequent when receiving from multiple

Chapters

Table of Contents

D067 D069 D068