Canon iR8500 Service Manual page 759

SERVICE MODE
COPIER>TEST
<NETWORK>
Use it to check network-related connections.
PING
Use it to check the connection of the machine and the network (only when
TCP/IP is in use).
<Using the Mode>
• At Time of Installation or a Connection Fault
1) Turn off the main power switch.
2) Connect the network cable to the machine, and turn on the main power
3) Inform the user's system administrator that the machine has been in-
4) Inform the user's system administrator that a check will be made on the
5) Make the following selections in service mode: COPIER>TEST>
•
S-116
Use it to check the connection to the network at time of installation
or when a fault occurs.
<NETWORK>
OK/NG
switch.
stalled, and ask him/her to make network settings.
network connection, and find out the remote host address (IP address of
the PC terminal on the user's network) for a PING command.
NETWORK>PING. Then, enter the IP address found in step 4); press
the OK key, and then press the Start key.
If the connection to the network is normal, 'OK' will be indicated (End
the work).
COPYRIGHT© 2001 CANON INC.
< 1/1 > <READY >
0 . 0 . 0 .
+/-
F00-206-11
2000 2000 2000 2000 CANON iR8500/7200 REV.1 AUG. 2001
0
IP Adress
OK