Canon iR8500 Service Manual page 73

CHAPTER 2 NEW FUNCTIONS
b. Points to Note When Replacing the Scanning Lamp
Do not work if the surface of the scan-
ning lamp is hot.
Do not leave fingerprints on the surface
of the scanning lamp.
If the surface of the scanning lamp is
soiled, dry wipe it.
When mounting the scanning lamp
heater [2] to the scanning lamp [1], be
sure to fit it with reference to the mark-
ing [3] (The connector [4] of the scan-
ning lamp heater must be to the front of
the machine).
Also, make sure that the distance A be-
tween the top edge of the scanning lamp
and the top edge of the light opening [5]
is about 6 to 7 mm when viewed from
the side.
When mounting the scanning lamp to
the machine, be sure not to touch the
light opening [5].
Be sure to mount the scanning lamp so
that the notation/marking is to the upper
front of the machine.
2-18
COPYRIGHT© 2001 CANON INC.
4 mm (approx.)
[3]
A
F02-209-09
2000 2000 2000 2000 CANON iR8500/7200 REV.1 AUG. 2001
[4]
[2]
[2]