Canon iR8500 Service Manual page 745

SERVICE MODE
COPIER>OPTION
CONTROL
PDL count function (not used in the machine)
Setting 0: do not count PDL output
1: count PDL output if control card is connected
B4-L-CNT
For soft counters 1 through 6, set B4 as large-size or small-size.
Setting 0: count as small-size (default)
1: count as large-size
TRY-STP
Use it to prohibit suspension of printing in response to a limit in the number
of sheets to staple or the presence of mixed sizes in the finisher.
Setting 0: normal mode (suspend printing in response; default)
1: suspend when height sensor (full stack) goes ON
MF-LG-ST
Use it to indicate the Extra Length key for papers as long as 630 mm
(manual feed; free size); for the ADF, up to 630 mm.
Setting 0: normal mode (default)
1: extra-length mode (indicate key)
SPECK-DP
Use it to enable/disable the indication of the result of dust detection in
stream reading mode.
Setting 0: disable (default)
1: enable
CNT-DISP
Use it to enable/disable the indication of the serial number in response to a
press on the Counter Check key.
Setting 0: enable (default)
1: disable
PH-D-SEL
Use it to select the number of lines for photo mode.
Setting 0: 141 lines (default)
1: 134 lines
COPY-JOB
Use it to enable/disable a copy job when a card reader or the coin vendor is
used.
Setting 0: copy job auto start enabled (default)
1: copy job auto start disabled
S-102
COPYRIGHT© 2001 CANON INC. 2000 2000 2000 2000 CANON iR8500/7200 REV.1 AUG. 2001