Canon iR8500 Service Manual page 376

No.
15 Using 8 screws [1], mount the relay PCB
and the LIPS PCB.
16 Mount the differential PCB removed in
step 11 using 4 screws, and connect the 2
connectors disconnected in step 10); then,
fix the connector harness in place using
the wire saddle.
17 Mount the main controller cover removed
in step 9) (Be sure that both screws are on
the hook side).
18 Mount the system connector cover
removed in step 4).
19 Mount the interface cable removed in step
3).
20 Mount the rear cover removed in step 2).
21 Connect the copier's power plug, and turn
on the main power switch.
22 Start user mode.
23 Change the setting of the following from
'no' to 'yes': user mode>printer settings>
settings>auto switch-over>LPS.
24 Change the setting of the following from
'no' to 'yes': user mode>printer settings>
settings>auto switch-over>N201.
25 Change the setting of the following from
'no' to 'yes': user mode>printer settings>
settings>auto switch-over>ESC/P.
26 Connect to the network (See 3.13
"Connecting to the Network").
COPYRIGHT© 2001 CANON INC.
Work
2000 2000 2000 2000 CANON iR8500/7200 REV.1 AUG. 2001
CHAPTER 4 INSTALLATION
Checks/remarks
[1]
F04-701-14
[1]
[1]
4-75