Canon iR8500 Service Manual page 456

10) Connect the cable [1] of the potential sensor checking electrode to the frame (GND) [2]
of the machine.
Be sure to allow enough space from the window of the sensor so the the
clip will not come into contact with the cover of the sensor.
11) Insert the door switch actuator into the door switch assembly.
12) Connect the power plug to the power outlet, and turn on the main power switch.
13) Execute the following in service mode: COPIER>FUNCTION>DPC>OFST.
14) Record the setting of 'OFST' on the service label.
15) Turn off the main power switch.
16) Disconnect the power plug from the power outlet.
17) Detach the potential sensor checking electrode.
18) Put the potential sensor support plate back into its initial position.
19) Connect the power plug to the power outlet, and turn on the main power switch.
COPYRIGHT© 2001 CANON INC.
F06-207-10
2000 2000 2000 2000 CANON iR8500/7200 REV.1 AUG. 2001
CHAPTER 6 TROUBLESHOOTING
[2]
[1]
6-53