Canon iR8500 Service Manual page 179

CHAPTER 2 NEW FUNCTIONS
3) Free a length of about 5 cm from a
charging wire reel (wire dia. of 0.06
mm), and form a loop at the end about 2
mm in diameter.
To form a loop, wind the charg-
ing wire once around a hex key,
Memo
and twist the key 3 to 4 times.
4) Cut the end (excess) for the twisted
charging wire.
5) Hook the loop on the stud.
6) Hook the charging wire on the charging
wire positioner at the rear, and hook the
charging wire tension spring on the
charging wire, and twist it.
7) Cut the excess of the charging wire with
a nipper.
8) Pick the end of the charging wire ten-
sion spring with tweezers, and hook it
on the charging wire terminal. In the
case of the pre-transfer charging assem-
bly, hook the spring at the front.
Be sure of the following:
• The charging wire is free of
bends and twists.
• The charging wire is in the
bottom of the V-groove of the
charging wire positioner.
2-124
COPYRIGHT© 2001 CANON INC.
Stud
Charging wire
(front)
F02-709-13
F02-709-14
F02-709-15
Grid side
(correct)
F02-709-16
2000 2000 2000 2000 CANON iR8500/7200 REV.1 AUG. 2001
Charging
Reel
terminal
(rear)
(wrong)