Canon iR8500 Service Manual page 413

CHAPTER 6 TROUBLESHOOTING
2) Check to make sure the setting of the following is '106':
COPIER>ADJUST>BLANK>BLANK-T. If not, enter '106'.
3) Adjust the image leading edge margin as follows:
Generate output by making the following selections: COPIER>TEST>PG5; then, check
the image leading edge margin.
Standard: 4 +1.5, −1.0 mm
Mode: COPIER>ADJUST>FEED-ADJ>REGIST
• A higher setting increases the margin.
• A lower setting decreases the margin.
4) Adjust the image trailing edge margin as follows:
Generate output by making the following selections: COPIER>TEST>PG5; then, check
the image trailing edge margin.
Standard: 2.5 ±1.5 mm
Mode: COPIER>ADJUST>BLANK>BLANK-B
• A higher setting increases the margin.
• A lower setting decreases the margin.
6-10
COPYRIGHT© 2001 CANON INC.
4+1.5mm,-1.0mm
F06-201-02
F06-201-03
2000 2000 2000 2000 CANON iR8500/7200 REV.1 AUG. 2001
+
2.5 1.5mm