Front-Mounting The Switch In A Two-Post Rack - Extreme Networks Summit X150 Series Hardware Installation Manual

Front-Mounting the Switch in a Two-Post Rack

To front-mount the switch in a two-post rack:
1 Place the switch upright on a secure work surface.
2 Place a front mounting bracket over the mounting holes on one side of the unit, with the flange at
the front of the switch
3 Insert and tighten seven screws to secure the bracket to the side of the switch.
Figure 158: Attaching a Front Mounting Bracket
4 Repeat steps 2 and 3 to attach the remaining front bracket to the other side of the switch.
5 Slide the switch into the rack until the mounting bracket flanges are against the rack posts
(Figure 159).
6 At each side, fasten the mounting bracket to the rack post using suitable screws.
Figure 159: Front-Mounting a Switch
After the switch is secured to the rack, install and connect power supplies as described on
AC power supplies or on
NOTE
If you are installing a VIM2 module, install it in the switch before you connect the switch to power
Summit Family Switches Hardware Installation Guide
(Figure 158).
page 212 for DC power supplies.
Installing a Summit X480 Series Switch
SH_143
SH_144
page 210 for
207