Removing A Summit X650 Series Switch From A Cabinet Or Four-Post Rack - Extreme Networks Summit X150 Series Hardware Installation Manual

Removing a Summit Family Switch from a Rack
Removing a Summit X650 Series Switch from a Cabinet or
Four-Post Rack
Removing the Summit X650 switch from a cabinet or rack requires two people to maneuver the switch
and disconnect the mounting hardware.
To remove the Summit X650 series switch from a cabinet or four-post rack:
1 Disconnect all power cords from the back of the switch.
2 Remove all installed power supplies:
a Push the latching tab to the left as you pull the handle to disengage the power supply from its
internal connectors.
b Carefully slide the power supply out of the switch and set it aside.
3 Support the front of the switch while you remove the front rack mounting screws
4 Carefully slide the switch forward out of the cabinet and off the rear mounting brackets.
Figure 274: Removing the Switch from a Cabinet
5 Set the switch on a secure work surface. Using a #1 Phillips screwdriver, remove the front mounting
brackets from the sides of the switch.
6 Remove the rear mounting brackets from the rear rack posts.
324
SH_104
Summit Family Switches Hardware Installation Guide
(Figure 274).