Installing A Summit X460 750 W Ac Power Supply - Extreme Networks Summit X150 Series Hardware Installation Manual

Installing Summit Family Switches

Installing a Summit X460 750 W AC Power Supply

WARNING!
To prevent an electrical hazard, make sure that the AC power cord is not connected to the power supply
before you install the power supply in the power supply bay.
CAUTION
Make sure that the AC power supply circuit is not overloaded. Use proper over-current protection, such as
a circuit-breaker, to prevent over-current conditions.
To install a Summit X460 750 W AC power supply:
1 If necessary, remove a blank panel from the back of the Summit X480 series switch
Figure 142: Removing a Blank Panel
2 Verify that the power supply is right side up (see
3 Carefully slide the power supply all the way into the power supply bay (see
power supply in until the latch snaps into place.
CAUTION
Do not slam the power supply into the switch.
194
SH_204
Figure 143).
Summit Family Switches Hardware Installation Guide
(Figure 142).
Figure 143). Push the