Extreme Networks Summit X150 Series Hardware Installation Manual page 294

Replacing DC Power Supplies in Summit Family Switches
To connect the DC power cables to the Summit 450 W DC power supply:
1 Verify that the DC circuit is de-energized.
2 Connect the DC power input cables as follows:
a On each terminal, loosen the screw enough to allow the spade terminal to slide underneath the
captive square washer
b Slide the spade terminal of the negative wire (–48 V) under the captive square washer on the
negative terminal (labeled –).
c Slide the spade terminal of the positive wire (–48 V RTN) under the captive square washer on the
positive terminal (labeled +).
Figure 244: Connecting the DC Power Cables (Part 1)
-48V
d Tighten both screws on the terminal block to 7 inch-pounds (0.99 Newton meters)
294
(Figure 249).
(+)
(–)
RTN
SH_161
Summit Family Switches Hardware Installation Guide
(Figure 245).