Attaching The Dc Wiring Harness To The Dc Power Socket On The Switch - Extreme Networks Summit X150 Series Hardware Installation Manual

Installing a Summit Family Switch (Models Other than Summit X460, X480, and X650 Series)

Attaching the DC Wiring Harness to the DC Power Socket on the Switch

After the DC wiring harness is connected to a permanent DC voltage source by a qualified, licensed
electrician, you can remove, replace, and maintain the Summit DC-powered switch without further
electrician assistance.
NOTE
Be sure that the DC circuit is de-energized before you connect the DC wiring harness to the DC
power socket.
CAUTION
Be sure that proper ESD controls are in use before switch maintenance is performed. This includes but is
not limited to wrist straps that are grounded to the switch chassis and earth grounds.
To attach the DC wiring harness to the internal DC power supply:
1 Plug the DC wiring harness connector into the DC power supply socket on the rear of the switch
(see Figure 135).
The pins must align properly for the cable to completely connect. Do not force the cable into the
socket until the keyway is aligned properly. Refer to
Figure 135: DC Power Socket on a Summit X450a Series DC-Powered Switch
NOTE
Figure 135 shows the rear panel of a Summit X450a series DC-powered switch. The rear panel of other
Summit DC-powered switches may vary slightly; however, the DC power socket is of the same type and the
connection process is the same for all DC-powered switches.
2 Tighten the retainer nut on the connector until it is finger-tight.
3 Energize the DC circuit.
Summit Family Switches Hardware Installation Guide
Figure 134 for the DC wiring harness connector.
-48 V
2 . 0 A M a x
SH_235
187