Extreme Networks Summit X150 Series Hardware Installation Manual page 255

Figure 206: Attaching the Mounting Bracket
c Repeat steps a and
4 Slide the EPS-C into a 19-inch rack and secure it using appropriate rack-mount screws.
5 Connect the keyed end of the redundant power cord to the EPS-C (see
side of the connector marked TOP is facing up.
The key is a plastic tab on the cable connector housing that fits into the EPS-C to ensure correct
alignment of the connector.
6 Connect the other end of the redundant power cord to the Summit X450e-48p or X250e-48p switch
(see Figure 207). Be sure that the side of the connector marked TOP is facing up.
Figure 207: Installing the Redundant Power Cord
Connect First
Redundant Power Output
! See Manual
Summit Family Switches Hardware Installation Guide
EPS-C
Rack Mount Bracket
b for the other side of the EPS-C.
Installing an EPS-600LS External Power Module
C
S -
E P
EPS-C_01
Figure 207). Verify that the
EPS-C_03A
255