Installing The Replacement Power Supply - Extreme Networks Summit X150 Series Hardware Installation Manual

Figure 240: Removing a Summit X480 DC Power Supply
6 Carefully slide the power supply the rest of the way out of the switch.
7 If a replacement power supply will not be installed, install a cover over the unoccupied power
supply bay.
NOTE
Unoccupied power supply bays must always be covered to maintain proper system ventilation
and EMI levels.

Installing the Replacement Power Supply

To install a replacement Summit 450 W DC power supply:
1 Verify that the power supply is right side up (see
2 Carefully slide the power supply all the way into the power supply bay (see
power supply in until the latch snaps into place.
CAUTION
Do not slam the power supply into the switch.
Figure 241: Installing a Summit 450 W DC Power Supply
3 Reconnect the ground wire as described in the next section.
Summit Family Switches Hardware Installation Guide
Replacing a Summit 450 W DC Power Supply
SH_163
Figure 247)
SH_158
Figure 247). Push the
291