Chapter 9: Replacing Ac Power Supplies In Summit Family Switches; Replacing A Summit X460 Ac Power Supply - Extreme Networks Summit X150 Series Hardware Installation Manual

9
C H A P T E R
This chapter describes how to replace AC power supplies in a Summit X460, X480, X650, or X670 series
switch. These switches have two bays for hot-swappable power supplies. In a switch with a redundant
power configuration, you can replace one Summit AC power supply without powering down
the switch.
This chapter includes the following sections:
Replacing a Summit X460 AC Power Supply on page 275
●
Replacing a Summit 450 W AC Power Supply on page 280
●
Replacing a Summit X650 AC Power Supply on page 282
●
Removing EPS Series AC Redundant Power Supplies on page 284
●
NOTE
Read the information in this chapter thoroughly before attempting to replace one of the listed
Summit X650 components.

Replacing a Summit X460 AC Power Supply

The Summit X460 series switches have two bays for hot-swappable power supplies. In a switch with
a redundant power configuration, you can replace one Summit AC power supply without powering
down the switch.
You need the following tools and materials to replace a Summit X460 AC power supply:
Thermal protective gloves
●
AC power cord, if you will not be re-using the cord from the removed power supply
●
An AC power cord is not included with the Summit X650 AC power supply. You must obtain a
power supply cord that meets the requirements listed under
page 333.
To replace a Summit X460 AC power supply:
1 Disconnect the AC power cord from the wall outlet and from the power supply.
2 Note the orientation of the installed power supply, and the location of the latching tab (at the right
or the left, depending on the specific power supply model).
Summit Family Switches Hardware Installation Guide
Replacing AC Power Supplies in
Summit Family Switches
"Selecting Power Supply Cords" on
275