Installing A Summit X650 Ac Power Supply - Extreme Networks Summit X150 Series Hardware Installation Manual

Installing Summit Family Switches

Installing a Summit X650 AC Power Supply

CAUTION
Make sure that the AC power supply circuit is not overloaded. Use proper over-current protection, such as
a circuit-breaker, to prevent over-current conditions.
To install a Summit X650 AC power supply:
1 Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an appropriate
grounding point.
2 If necessary, remove a blank panel from the back of the Summit X650 series switch
Figure 182: Removing a Blank Panel
3 Verify that the power supply is right side up, with the latching tab at the right of the unit (see
Figure 183).
4 Carefully slide the power supply all the way into the power supply bay (see
power supply in until the latch snaps into place.
CAUTION
Do not slam the power supply into the switch.
226
SH_088
Figure
Summit Family Switches Hardware Installation Guide
(Figure 182).
183). Push the