Summit Xgm-2Xn Option Card; Mixing Zr Xenpaks With Other Types - Extreme Networks Summit X150 Series Hardware Installation Manual

Summit XGM-2xn Option Card

The Summit XGM-2xn option card allows you to add one or two 10-gigabit XENPAK modules to the
following switches:
Summit X450-24x switch, running ExtremeXOS 11.2.0 (or later)
●
Summit X450-24t switch, running ExtremeXOS 11.2.0 (or later)
●
For current information about compatible XENPAK modules and the minimum required software, refer
to the most recent version of the ExtremeXOS Release Notes.
For more information about XENPAK modules, refer to the Extreme Networks Pluggable Interface Modules
Installation Guide.
NOTE
The ExtremeXOS software also recognizes standards-based CX-4 XENPAKs; contact your CX-4 module
vendor to obtain these.

Mixing ZR XENPAKs with Other Types

Table 43 lists the supported combinations of XENPAK types using ZR XENPAKs in a Summit X450
series switch. You can either install one ZR XENPAK and leave one slot empty or install one ZR
XENPAK and one SR XENPAK. The Summit X450 series switch does not support any other XENPAK
combinations when a ZR XENPAK module is installed. You must put the specified modules in the
specified slots, as shown in
.
Table 43: Summit X450 ZR XENPAK Combinations
Left Slot
ZR XENPAK
ZR XENPAK
Summit Family Switches Hardware Installation Guide
Table 43, for the switch to discover the ZR XENPAK correctly.
Right Slot
Empty
SR XENPAK

Summit XGM-2xn Option Card

119