Installing Summit X650 Power Supplies; Ac Power Supply Cords - Extreme Networks Summit X150 Series Hardware Installation Manual

Figure 181: Securing the Switch to the Front Rack Posts—Cabinet Installation
After the switch is secured to the rack, install and connect power supplies as described in
Summit X650 AC Power Supply"

Installing Summit X650 Power Supplies

The Summit X650 series switch is shipped without installed power supplies. The switch accommodates
one or two Summit X650 power supply units.

AC Power Supply Cords

An AC power cord is not included with the Summit X650 AC power supply. AC power cords for use in
the US and Canada from Extreme Networks or from your local supplier. The cord must meet the
following requirements:
The power cord must be agency-certified for the country of use and rated for 100-240 V AC.
●
The power cord must have an IEC 320 C13 connector for connection to the power supply.
●
The power cord must have an appropriately rated and approved wall plug applicable to the country
●
of installation.
For cords up to 6 feet (2 m) long, the wire size must be 18 AWG (.75 mm
●
minimum wire size is 16 AWG (1.0 mm
For additional power cord requirements, see
Summit Family Switches Hardware Installation Guide
or "Installing a Summit X650 DC Power Supply" on page
2
).
"Selecting Power Supply Cords" on page

Installing Summit X650 Power Supplies

SH_084
"Installing a
228.
2
) minimum; over 6 feet, the
333.
225