Removing A Switch From A Four-Post Rack - Extreme Networks Summit X150 Series Hardware Installation Manual

Removing a Summit X480 Series Switch

Removing a Switch from a Four-Post Rack

Removing the Summit X480 switch from a cabinet or four-post rack requires two people to maneuver
the switch and disconnect the mounting hardware.
To remove the Summit X480 series switch from a cabinet or four-post rack:
1 Verify that all power supplies have been removed from the switch.
2 Support the front of the switch while you remove the front rack mounting screws (Figure 268).
3 Carefully slide the switch forward out of the cabinet and off the rear mounting brackets.
Figure 268: Removing the Switch from a Four-Post Rack
SH_148
4 Set the switch on a secure work surface. Using a #1 Phillips screwdriver, remove the front mounting
brackets from the sides of the switch.
5 Remove the rear mounting brackets from the rear rack posts.
Summit Family Switches Hardware Installation Guide
319