Connecting The Ground Wire - Extreme Networks Summit X150 Series Hardware Installation Manual

Installing Summit Family Switches
4 Carefully slide the power supply all the way into the power supply bay (see
power supply in until the latch snaps into place.
CAUTION
Do not slam the power supply into the switch.
Figure 168: Installing a DC Power Supply
5 To install a second power supply, repeat steps 2 through 4.

Connecting the Ground Wire

WARNING!
Be sure to connect the chassis ground wire before you connect any power cables.
Be sure to disconnect the ground wire after you disconnect all power cables.
You need a #1 Phillips screwdriver to secure the ground wire to the power supply.
To connect the ground wire:
1 Verify that the DC circuit is de-energized.
2 Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an appropriate
ground point on the rack.
3 Pull the cover off the terminal block
214
(Figure 169).
Summit Family Switches Hardware Installation Guide
Figure 168). Push the
SH_158