Chapter 12: Replacing Port Option Cards And Vims; Replacing A Summitstack Or Summitstack-V80 Stacking Module - Extreme Networks Summit X150 Series Hardware Installation Manual

12
C H A P T E R
This chapter describes how to replace port option cards, stacking modules, and versatile interface
modues (VIMs) in a Summit X460, X480, X650, or X670 series switch. This chapter includes the
following sections:
Replacing a SummitStack or SummitStack-V80 Stacking Module on page 305
●
Replacing an XGM3 Port Option Card in a Summit X460 Series Switch on page 306
●
Replacing a Versatile Interface Module (VIM) in a Summit X480, X650 or X760 Series Switch on
●
page 308
Replacing XGM and XGM2 Series Port Option Cards on page 310
●
NOTE
Read the information in this chapter thoroughly before attempting to replace one of the listed Summit X650
components.
Replacing a SummitStack or SummitStack-V80
Stacking Module
The replacement process is the same for either a SummitStack or a SummitStack-V80 stacking module in
a Summit X460 series switch. You need the following tools to replace a stacking module:
ESD-preventive wrist strap
●
Screwdriver
●
To replace a stacking module:
1 Attach an ESD-preventive wrist strap to your wrist and connect the metal end to an appropriate
ground point on the rack.
2 Completely loosen the captive retaining screws and slide the installed stacking module out of the
switch (Figure 253).
Summit Family Switches Hardware Installation Guide
Replacing Port Option Cards
and VIMs
305