Preparing The Cables; Installing The Power Supply - Extreme Networks Summit X150 Series Hardware Installation Manual

Installing Summit Family Switches

Preparing the Cables

A ring terminal and two spade terminals are provided with the power supply. You need a crimping tool
to attach the terminals to the power and ground cables.
To prepare the cables:
1 On each wire, strip 0.25 inch of insulation from one end.
2 Insert the stripped wire end all the way into the barrel of the terminal
terminal securely to the wire.
Be sure to attach the ring terminal to the green/yellow wire.
Figure 147: Attaching Terminals to Cables
Power connection wire

Installing the Power Supply

CAUTION
The handle on the Summit X460 DC power supply is not designed to be used to lift or carry the Summit
X460 series switch.
To install a Summit X460 DC power supply:
1 Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an appropriate
ground point on the rack.
2 If necessary, remove a blank panel from the back of the Summit X460 series switch
Figure 148: Removing a Blank Panel
198
SH_109
SH_207
Summit Family Switches Hardware Installation Guide
(Figure 147) and crimp the
Ground wire
(Figure 148).
SH