Preparing The Cables; Installing The Power Supply - Extreme Networks Summit X150 Series Hardware Installation Manual

Preparing the Cables

Three spade-type terminals are provided with the power supply. You need a crimping tool to attach the
terminals to the power and ground cables.
To prepare the cables:
1 On each wire, strip 0.25 inch of insulation from one end.
2 Insert the stripped wire end all the way into the barrel of the terminal
terminal securely to the wire.
Figure 166: Attaching a Terminal to a Cable

Installing the Power Supply

To install a Summit 450 W DC power supply:
1 Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an appropriate
ground point on the rack.
2 If necessary, remove a blank panel from the back of the Summit X480 or X670 series switch
(Figure 167).
Figure 167: Removing a Blank Panel
3 Verify that the power supply is right side up (see
Summit Family Switches Hardware Installation Guide
Installing Summit 450 W Power Supplies
(Figure
SH_109
SH_157
Figure 168).
166) and crimp the
213