Attaching The Switch To A Two-Post Rack - Extreme Networks ExtremeSwitching SLX 9250 Hardware Installation Manual

Installing Your Switch
The completed assembly is shown in the Figure Completed Installation: Switch in 4-Post Rack.
Figure 14: Completed Installation: Switch in 4-Post Rack
13. Verify that the switch is leveled and is firmly attached to the rack.
If your switch comes with installed AC power supplies, skip to
If your switch does not have an installed power supply, install one or two power supplies using the
instructions in

Attaching the Switch to a Two-Post Rack

You can attach your switch to a two-post rack in either of two configurations:
•
Front mount
•
Mid-mount
The side of the switch has different sets of holes for attaching mounting brackets in either configuration.
Brackets for a two-post mount are not included in the box with your switch. However, they can be
ordered separately using part number XN-2P-RKMT299.
Installing a 750 W Internal AC Power Supply
ExtremeSwitching SLX 9250 Hardware Installation Guide
Attaching the Switch to a Two-Post Rack
Powering up the Switch
on page 50 .
on page 57 .
43