Installing A Stacking Module In A Summit X460 Series Switch - Extreme Networks Summit X150 Series Hardware Installation Manual

Installing a Stacking Module in a Summit X460 Series Switch

Installing a Stacking Module in a Summit X460 Series
Switch
In the Summit X460 series switch, a stacking module can be installed in Slot B on the back panel of
the switch.
To install a stacking module:
1 Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an appropriate
ground point on the rack.
2 At the back of the switch, remove the cover from Slot B (Figure 222).
Figure 222: Removing the Slot B Cover
SH_216
3 Carefully slide the stacking module all the way into the slot (Figure 223).
4 Align and fully tighten the captive retaining screws.
Figure 223: Installing a Stacking Module (SummitStack module shown)
SH_217
Summit Family Switches Hardware Installation Guide
271