Table of Contents
Advertisement
6.11 Lighting unit
6.11.1 Replacing Headlight
•
4 mm Allen key
•
6 mm Allen key
•
10 mm socket wrench
•
19 mm socket wrench
1. Remove drive wheel. Refer to 6.8.6 Replacing Drive
Wheel (1–Bolt Installation), page 37.
2. Remove top screws B securing fender bracket A to
gearbox C.
3. Disconnect headlight cable F.
4. Remove nuts H securing fender D and light bracket G
to fender bracket E.
5. Remove light bracket.
6. Install parts in reverse order.
Tighten the hardware as listed below:
•
Light bracket nuts H to 4 Nm
•
Fender bracket screws B to 18 Nm
•
Drive wheel nut to 61 Nm
6.11.2 Replacing Rear Light
This component is not serviceable. Replace the bottom part of the rear shroud instead.
6.12 Seating
This chapter deals with the replacement of interface components between the base of the mobility device and the
corresponding seating system.
For detailed instructions on the seating system, see the service manual of the corresponding seating system.
6.12.1 Replacing Height Adjustment Bracket — Tilt and Lifter-Tilt Modules
This chapter deals with replacing the height adjustment brackets for a seat with tilt or lifter-tilt module. Replacing the
brackets by other variants (see spare parts catalogue) allows to retrofit another seat height to the mobility device.
CAUTION!
Risk of Crushing to Hands and Feet by Weight of Component
– Pay attention to hand and feet.
– Use proper lifting techniques.
1675507-A
Fig. 6-58
Fig. 6-59
Service
53
Advertisement
Table of Contents
