SERVICE MANUAL
8.17.3 Replacing the lifter / seat angle adjustment module
Note
Replacement of the seat angle adjustment module is performed in the same manner.
ATTENTION: Danger of crushing!
The seat is very heavy. Danger of injury to hands and feet!
· Use proper lifting techniques
Requirements:
· 3 mm Allen key
· 5 mm Allen key
· T25 Torx wrench
· T40 Torx wrench
· Side cutting pliers
· Cable ties
· Remove legrests.
· Tilt the seat tilting completely to the rear if
possible.
· Switch the electronics OFF on the remote.
· Remove the backrest cushion.
· Loosen and remove the screws, which secure
the middle seat plate (A) with a 3 mm Allen key.
· Remove the middle seat plate (B).
· Loosen and remove the screws on both sides,
which secure the lateral seat plates (C) with a
3 mm Allen key.
· Remove the lateral seat plates (D).
or
· Remove the seat cushion.
· Loosen and remove the screws on both sides,
which secure the sling seat (A) with a
T25 Torx wrench.
· Remove the sling seat (B).
104
®
Invacare
- Kite