Invacare® Storm4 Series
6.9.7 Replacing lighting/actuator module CLAM
Tools:
•
Phillips screwdriver size 2
•
3 mm Allen key
•
4 mm Allen key
•
8 mm socket spanner
Dismantling CLAM
1. If possible, use the lifter to move the seat to the
uppermost position.
2.
Switch OFF electronics on remote.
3. Remove seat plate or sling seat (1), see "Adjusting seat
width (Modulite seat)".
4. Remove cover (2).
5. Pull all plugs out of lighting/actuator module CLAM.
6.
Loosen and remove relais (see"Replacing relais").
7. Loosen screws (1) with 3 mm Allen key and remove
screws including CLAM mounting (2).
8. Replace lighting/actuator module CLAM (3).
When disassembling, take care of small parts such as
screws and washers. Put all small parts down so that
they can be reassembled in the right sequence.
Refitting CLAM
1. Refit parts in reverse order.
2. Plug all the plugs into their old positions.
3. Check all mobility device functions.
6.9.8 Replacing solid angle sensor bracket
•
Philips screwdriver
44
Removing solid angle sensor bracket
1. Loosen and remove screw B on stabilization bracket A.
2. Pull out solid angle sensor bracket C from under
stabilization bracket.
3. Loosen and remove screws D.
4. Take off solid angle sensor box E from solid angle
sensor bracket.
5. Replace solid angle sensor bracket.
Installing solid angle sensor bracket
1. Install parts in reverse order.
6.9.9 Replacing USB charger
•
Allen wrench
Removing USB charger
1. Loosen and remove screw D including washer C.
2. Take off USB charger B from telescopic seat frame A.
3. Replace USB charger.
Installing USB charger
1. Install parts in reverse order.
6.9.10 Replacing Gyro plate
•
10 mm wrench
1533060-M