Icom MarineComander MXS-5000 Instruction Manual page 60

2
PLOTTER OPERATION
Chart Setup (MENU
■
<Mixing Levels menu>
<Chart Offset menu>
w Chart Setup) (Continued)
D Mixing Levels function
(MENU w Chart Setup u Mixing Levels)
The Mixing Levels function enables the different scale
map to display on the plotter display.
Push [MENU], then rotate [DIAL] until the "Chart
q
Setup" menu is highlighted, then push [ENTER].
Rotate [DIAL] until the "Mixing Level" menu is high-
w
lighted, then push [ENTER].
Rotate [DIAL] to turn the Mixing Level function ON
e
or OFF.
• OFF : The Mixing Level function is OFF. If the
details maps have a different scale, the
boundary line of these maps are shown
with a gray box.
• ON : If the details maps have a different scale, the
boundary line of these maps are mixed.
r Push [ENTER] to set, then exit the "Mixing Level"
menu.
• To cancel the setting, push [CLEAR].
D Chart Offset function
(MENU w Chart Setup u Chart Offset)
The Chart Offset function shifts the plotter map ac-
cording to the offset value, without changing vessel's
current latitude/longitude data.
Push [MENU], then rotate [DIAL] until the "Chart
q
Setup" menu is highlighted, then push [ENTER].
Rotate [DIAL] until the "Chart Offset" menu is high-
w
lighted, then push [ENTER].
Rotate [DIAL] to turn the Chart Offset function ON
e
or OFF.
• OFF : The Chart Offset function is OFF.
• ON : The plotter map shifts according to the off-
set value, without changing vessel's current
position data.
r Push [ENTER] to set, then exit the "Chart Offset"
menu.
• To cancel the setting, push [CLEAR].
To set the offset value for this function, see 'Offset at
Cursor setting,' 'Offset N-S setting' or 'Offset E-W set-
ting' as described on the next page.
2-44