Icom MarineComander MXS-5000 Instruction Manual page 159

<ATA & AIS Alarm menu>
<CPA menu>
<TCPA menu>
D ATA & AIS
Push [MENU], then rotate [DIAL] until the "Tool"
q
menu is highlighted, then push [ENTER].
Rotate [DIAL] until the "ATA & AIS" menu is high-
w
lighted, then push [ENTER].
Rotate [DIAL] until the desired menu is highlighted,
e
then push [ENTER].
• ATA & AIS Alarm
(MENU w Tool u ATA & AIS u ATA & AIS Alarm)
The ATA and AIS Alarm function can be turned ON or
OFF.
• OFF : The ATA and AIS Alarm function is OFF.
• ON : The ATA and AIS alarm is emitted when
both CPA and TCPA reaches the limit.
• CPA
(MENU w Tool u ATA & AIS u CPA)
This setting helps you find a dangerous target to avoid
a collision with alarm when both CPA (Closest Point of
Approach) and TCPA (Time to CPA) becomes below
this setting value (the approach watch area).
Rotate [DIAL] to set the CPA value to between 0.50
➥
nm and 12.0 nm in 0.01 nm step. (Default: 0.50 nm)
• TCPA
(MENU w Tool u ATA & AIS u TCPA)
This setting helps you find a dangerous target to avoid
a collision with alarm when both CPA (Closest Point of
Approach) and TCPA (Time to CPA) becomes below
this setting value (the approach watch area).
➥ Rotate [DIAL] to select the TCPA value to between 0.5,
1, 2, 3, 4, 5, 6 and 12 minutes. (Default: 0.5 min.)
5-13
COMMON SETTING
5
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21