Table of Contents
Advertisement
• Name programming screen
• Group selection screen
• Symbol selection screen
• Latitude data programming screen
Name programming:
The Waypoint name is sequentially numbered when
it is created. Change it, if necessary.
q Rotate [DIAL] to select "Name," and push [EN-
TER].
w Input a waypoint name of up to 16 characters.
• See page 5-31 for programming details.
e Rotate [DIAL] to select "OK," then push [ENTER]
to set and return to the previous screen.
• If "Cancel" is selected, the "Setting Change" screen will
appear. Select "Yes" if you want to continue to program,
or select "No" if you want to cancel the program.
Group selection:
Make sure that the waypoint group has already been
created before selecting. (p. 5-6)
q Rotate [DIAL] to select "Group," and push [EN-
TER].
e Rotate [DIAL] to select the desired group, then
push [ENTER] to set and return to the previous
screen.
• If [CLEAR] is pushed, the setting will be cancelled.
Symbol selection:
q Rotate [DIAL] to select "Symbol," and push [EN-
TER].
w Rotate [DIAL] to select the desired symbol to indi-
cate the waypoint on the plotter display, then push
[ENTER] to set and return to the previous screen.
Latitude data programming:
q Rotate [DIAL] to select "Position Lat," and push
[ENTER].
w Rotate [DIAL] to set the latitude data, then push
[ENTER] to input it.
• Push [≈] to move the cursor forward.
• Push [Ω] to move the cursor backward.
• Select "N" to input N; North latitude.
• Select "S" to input S; South latitude.
2-7
PLOTTER OPERATION
Continued on the next page
☞
2
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
Advertisement
Chapters
Table of Contents
