Table of Contents
Advertisement
• Depth data programming screen
• Comment programming screen
<Navigation menu>
When the "Goto Waypoint..." menu is selected.
Navigation screen
Depth data programming:
q Rotate [DIAL] to select "Depth," and push [EN-
TER].
w Rotate [DIAL] to set the desired depth data, then
push [ENTER] to input it.
• Push [≈] to move the cursor forward.
• Push [Ω] to move the cursor backward.
Comment programming:
q Rotate [DIAL] to select "Comment," and push [EN-
TER].
w Input a comment of up to 32 characters.
• See page 5-31 for programming details.
e Rotate [DIAL] to select "OK," then push [ENTER]
to set and return to the previous screen.
• If "Cancel" is selected, the "Setting Change" screen will
appear. Select "Yes" if you want to continue to program,
or select "No" if you want to cancel the program.
After setting,
rotate [DIAL] to select "Save," then
➥
push [ENTER] to save the Waypoint and return to
the previous screen.
• If "Cancel" is selected, the "Setting Change" screen will
appear. Select "Yes" if you want to continue to program,
or select "No" if you want to cancel the program.
D Goto Waypoint navigation
(MENU w Navigation u Goto Waypoint...)
The Goto Waypoint navigation means that the vessel
is navigated from the current position to the specified
waypoint (within one section only).
Make sure that the waypoint has already been created.
(p. 2-6)
Push [MENU], then rotate [DIAL] until the "Naviga-
q
tion" menu is highlighted, then push [ENTER].
Rotate [DIAL] until the "Goto Waypoint..." menu is
w
highlighted, then push [ENTER].
Rotate [DIAL] to select the desired waypoint.
e
r Push [ENTER] to start the waypoint navigation.
• The navigation screen appears.
See page 2-12 to stop the navigation.
t
INFORMATION
✓
While navigation, the Reset XTE function can reset its
route to directly navigate to the destination from the
current position.
See page 2-13 for details.
2-9
PLOTTER OPERATION
2
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
Advertisement
Chapters
Table of Contents
