Icom MarineComander MXS-5000 Instruction Manual page 55

Beeps
<XTE Alarm menu>
<XTE Alarm Range menu>
XTE Alarm range
Destination
D XTE Alarm
(MENU w Alarm Setup u XTE Alarm)
Push [MENU], then rotate [DIAL] until the "Alarm Set-
q
up" menu is highlighted, then push [ENTER].
Rotate [DIAL] until the "XTE Alarm" menu is high-
w
lighted, then push [ENTER].
Rotate [DIAL] to turn the XTE Alarm function ON
e
or OFF.
• OFF : The XTE Alarm function is OFF.
• ON : The XTE Alarm function is ON. When your
vessel exits the XTE (Cross Track Error)
alarm zone, a beep sounds. When the ves-
sel reenters the alarm zone, the beeps
will stop. If the vessel exits the alarm zone
again, beeps sound.
r Push [ENTER] to set, then exit the "XTE Alarm"
menu.
• To cancel the setting, push [CLEAR].
To set the XTE alarm range, see 'XTE Alarm Range
setting' as described below.
D XTE Alarm Range setting
(MENU w Alarm Setup u XTE Alarm Range)
Push [MENU], then rotate [DIAL] until the "Alarm Set-
q
up" menu is highlighted, then push [ENTER].
Rotate [DIAL] until the "XTE Alarm Range" menu is
w
highlighted, then push [ENTER].
e Rotate [DIAL] to set the XTE Alarm Range to be-
tween 0.01 nm and 10.00 nm. (Default: 0.30 nm)
r Push [ENTER] to set, then exit the "XTE Alarm
Range" menu.
• To cancel the setting, push [CLEAR].
2-39
PLOTTER OPERATION
2
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21