3. Periodical check
3.5.5
Replacing the tray 1 feed roller/tray 1 pick-up roller
A. Periodically replacing parts/cycle
• Tray 1 feed roller: Every 300,000 prints
• Tray 1 pick-up roller: Every 300,000 prints
B. Procedure
1. Slide out the tray 1.
2. Remove the manual bypass tray unit.
See P.103
[1]
[1]
24
[1]
[2]
A02EF2C004DA
[2]
A02EF2C005DA
[2]
A02EF2C006DA
Field Service Ver. 3.0 Jan. 2008
3. Remove the harness cover [1], and
disconnect the connector [2].
4. Remove three screws [1], and
remove the tray 1 paper feed assy
[2].
NOTE
• The tray 1 paper feed assy is posi-
tioned by the shaft that passes
through the back frame of the assy.
When removing the tray 1 paper
feed assy, slide it in the direction of
the arrow.
5. Remove two springs [1], and remove
the cover [2].